- Hydraulic jack products
- PLC bridge hydraulic synchronous lifting system
- QFZ Tension Hollow Jack
- RSM series thin jack
- QFB type ultra-thin jack
- Self-locking jack
- QF type separate electric hydraulic jack
- HQ350 pneumatic hydraulic pump
- HQ225 pneumatic hydraulic pump
- HQ150 pneumatic hydraulic pump
- Electric oil pump
- Manual oil pump
- Heavy rail moving machine
- Hydraulic three-way jack (three-dimensional jack)
- Pipe jacking machine
- Hydraulic cylinder
- • Definition of hydraulic pipe bender
- • How to buy a hydraulic pipe bender?
- • Application examples of ultra-thin hydraulic jacks
- • The difference between electric hydraulic pipe bender
- • Overview of ultra-thin hydraulic jack performance
- • Instructions for use of ultra-thin hydraulic jacks
- • Description of the thin nut-locked hydraulic jack
- • A brief introduction of the split hydraulic jack
- • Precautions when using the synchronous jack system
- • What causes damage to the hydraulic jack
1. When the button of the synchronization jack is always on, pressing the button again has no effect. When the button light of the laminating button is flashing, pressing synchronous lifting has no effect.
2. When all the power cables and signal cables in the synchronization jack are connected, it is necessary to power off and plug in!
3. Non-professionals are not allowed to repair the equipment. Non-professionals modify the parameters of the “Parameter Setting” screen and the “Debug Setting” screen. This equipment must not be operated by untrained personnel.
4. After the cable sensor is pulled out, the cable cannot be loosened suddenly. The cable switch has a stroke of 0.5 meters. Do not exceed this stroke when using it.
5. At stations that are not used, try to loosen the self-locking button at each point to avoid misoperation.
6. When the device is temporarily not operating, please click the "Stop Operation" button on the operation screen of the motor touch screen. Prevent people from operating by mistake or by people. When you need to operate again, you can click the "Unlock" button on the operation screen on the touch screen to operate.
7. It is necessary for the synchronous jack to be connected to the ground wire, and the resistance of the ground wire should be less than 4 ohms, otherwise it will affect the equipment control accuracy.
Previous ： What are the working process of hydraulic pipe bender Next ： Development direction and influence of hydraulic pipe bender